Editing Hanb Installation Full Tutorial (section)

= Hanb Installation Full Tutorial =

== Introduction ==
This tutorial will guide you through the installation and setup of Hanb, a command that is often used in combination with Emacs and Neovim for a seamless coding experience.

== Requirements ==
* Working installation of Neovim
* Emacs installed on your system
* Basic familiarity with command line interfaces

== Steps to Install Hanb ==

=== Step 1: Open Neovim ===
1. Launch your terminal.
2. Type `nvim` to open Neovim.

=== Step 2: Install Hanb ===
1. In Neovim, enter command mode by typing `:`
2. Use the following command to install Hanb:
   ```
   :!git clone https://github.com/yourusername/hanb.git
   ```
3. Navigate into the Hanb directory:
   ```
   :!cd hanb && make install
   ```

=== Step 3: Configure Neovim ===
1. Open your Neovim configuration file:
   ```
   :e ~/.config/nvim/init.vim
   ```
2. Add the following line to configure Hanb:
   ```vim
   set shellcmdflag=-c
   ```

=== Step 4: Open Emacs in Neovim ===
1. To open Emacs from within Neovim, use the following command:
   ```
   :!emacs
   ```

== Conclusion ==
You have successfully installed Hanb and configured it to work with Neovim and Emacs. This setup will enhance your coding efficiency, especially during serious coding sessions.

== Further Reading ==
* Link to [Emacs Documentation](https://www.gnu.org/software/emacs/manual/)
* Link to [Neovim Documentation](https://neovim.io/)